...fly-wheel, both cam shaft pullies with notchs, now release the tnsion on the idler pullies, and retighten where they fell. check again on the 3 timing points be sure they have not moved again... ...
1987 Subaru GL Oil Pump location Does anyone know where it is located? Thank you. Assuming the car has the 1.8 engine, the oil pump is on the front of the motor, behind the timing belt covers. The ...
had a mechanic try to fix exhaust leak @ manifold, they broke bolt off then tapped hole @ an angle. still have leak.can I double up on the gasket to possibably fix problem If you think that the angled
How to change drive belts on 89 Subaru DL Wagon? The belts look a bit cracked and are in need of replacing. I'd like to do it myself, it seems easy. loosen appropriate pulley tensioner by loosening ...
Check engine light coming on off and on, seems to Check engine light started coming on off and on, seemed to happen with a change/drop in the idle speed. Light hasn't been on for several days but ...
...down the swivel screw securing the alternator. did you get the right length belt or correct belt? there should be a bolt to loosen or tighten your belt separate from the alternator.attach
1987 Subaru GL 1.8 liter automatic, 2WD. Fuel-injected. Quit running at 65MPH on freeway, coasted into parking lot. Parked. Cannot start. Noticed crank case was accidently overfilled on dip stick ...
does my 1984 subaru gl10 have a timing belt or chain Thanks It has a timing belt, the belt should be replaced every 52,000 miles
...the mounting bolts. Install the drive belt and adjust the tension as necessary. Tighten the alternator mounting bolts. Tighten the water pump pulley mounting bolts. Connect the negative battery
Question about 1987 Gl 4WD
1993 SUBARU LEGACY CRANKSHAFT PULLEY IS OF BEFORE FINDING TOP DEAD CENTER WHAT MUST I DO TO PROPERLY INSTALL THE CRANKSHAFT PULLEY IN RIGHT POSITION AND DOES THIS PULLEY GET A KEY STOCK INTO THE SLO ...
Usually answered in minutes!
97 Questions
60 Questions
48 Questions
48 Questions
40 Questions