...belt tension to 100 lb. B. Tighten in order, first tighten the locking bolt A to 27 Nm (20 ft. Ibs) then, bolt B to27Nm (20 ft. Ibs). Finally tighten the pivot bolt C to 54 Nm (40 ft. Ibs). Belt ...
...this will allow the pump slide down to replace belt, to tighten put pry bar on rad support and under the front of pump until the belt tension is proper, keeping tension on pry bar tighten
...pitch squeak i bought belt dressing and it worked only for a short time ,does my belt need to be tightened more,what could be wrong It sounds like the belt is not tight ...
...tension to slide the belts on and off. Once the new belt is on, apply pressure to get the belt tight (a long flathead screwdriver or crowbar should do) and while tight, re-tighten the adjusting
...tighten it, get a can of belt dressing from most parts stores, and spray some on it when the engine is running. You have to try and get some on the under side of the belt, so find a pulley that you ...
tighten the belt. It is the Tension arm/pulley's job to do so. If the belt is loose, then it either means the belt needs to be replaced, its the wrong belt, its routed wrong, or the tension pulley/arm
...belt. 17. Tighten the alternator pivot bolt to 40 ft. lbs. (54 Nm). 18. Install the B+ terminal wire and nut. Tighten the nut to 75 inch lbs. (9 Nm). 19. Attach the alternator field circuit wiring ...
...tighten the belt. Here is a link to a site that has the diagrams for both the serpentine belt models and regular belt models as well as timing belt diagrams: ...
Question about 2000 Neon
my brothers 2000 neon has a loss power steering belt how would i tighten it Loosen the nuts on the P/S pump. Pull it tight, then tighten the nuts.
...tighten my servinen belt in a 1996 dodge neon Have to loosen pivot bolt at bottom of power steering, plus top adjustment and use 1/2" drive bar in hole supplied in bracket to add tension, then ...
Usually answered in minutes!
861 Questions
762 Questions
743 Questions
710 Questions
606 Questions