Questions & Answers for: tighten belt Cars & Trucks

tighten that belt becasue it also runs the water pump and if u over tighten it and cause the pump bearing to fail and an water pump is an major repair on these engines because the water pump is behind

...4. Put on the new belt. 5. Slightly tighten the 13mm bolt, and use the crescent wrench to tighten the belt (using the half gear/half nut tightening assembly) 6. Tighten the 13mm. 7. Tighten the

...belt and lightly tighten bolts. Remove timing belt. Remove water pump and replace with new one. Suggest to replace cambelt as well. Installation Ensure timing marks aligned3 & 4. Fit timing belt ...

belt on and tighten belt so there is about 1/2" deflection when you push on the belt in the center of the pulleys, then tighten the bolts. u can do that, u have to check the all pully work or no work

...and tighten the belt as required. Once the belt is taut, but not stetched, simply tighten the two bolts up again and check that the belt has not lost its tension when you where tightening the

...Hold the bar to maintain this tension on the belt and tighten the top adjusting bolt. Re-tighten the two bottom bolts. Check the deflection of the belt once more to ensure it is not to

...the altenater and use a prying bar to tighten the belt by pushing the altnater so as to tighten the belt. while holding altenater in place tighten bolts back tight. Belt should be tight when

belt after you tighten it, you dont what the belt too tight, you should be able to grab belt and move in and out an inch. heres a diagram to make sure all timing marks are lined up. note if the timing

...belt to specification. Tighten the locking screw first, then the pivot screw. Tighten to 40 ft. lbs. (55 Nm). AIR PUMP DRIVE BELTSee Figure 17 Fig. Fig. 17: Air pump belt adjustment-2.2L engines When ...

Belt won't tighten on 98 dodge caravan. Does the Belt won't tighten on 98 dodge caravan. Does the altrenator tighten the belt or does tension pulley tighten it? If the alternator is fixed then its