Questions & Answers for: throttle pot

...throttle pot signal with high airflow sensor signal) 6 throttle pot/airflow sensor...... (high throttle pot signal with low airflow sensor signal) 7 throttle pot...idle fuel adjustment failure(idle ...

...throttle pot or the speed control pot My leanings is toward the throttle pot since it works in reverse with the speed pot not being changed but not forward. when you are just changing the position of ...

...throttle doesnt even turn properly now. sufi you will need to replace the speed control pot. Contact Pride @1-800-800-8586 ask for scooter tech support and explain your problem and ask about ordering ...

The little green light flashed 7 times Bad throttle pot or bad wiring to the throttle pot I would lean toward replacing the throttle pot Hope this helps

...check the spped control pot and the throttle pot. You will need a ohm meter to check both pots Usually replacing the speed pot will help but it could be both speed and throttle pot Hope this ...

throttle pot. Can that be corrected? The speed pot and throttle pots do wear in time. These parts are readily available and are not too difficult to change. A service manual can be downloaded from the

Throttle Pot or Speed Pot. The levers will change the resistance of the throttle pot. The speed pot feeds the throttle pot. Move the speed pot while pushing the lever forward. If it works could be the

...pot and throttle pot now my rascal 235 drives but only about half speed Sounds like one of them has incorrect values. You need to check the resistance marked on the original speed and throttle pots, ...

...throttle pot to stop this from happening. but the throttle has to be out of neutral position in order for it to move on startup. The throttle pots are normally 5k ohm pot, about 2.5k from the center ...

...throttle pot? I got 7 led flashes and I want to replace the throttle pot. But I don't know how do disassemble tiller console for reaching this pot. I need clear instructions. look under the bottom of ...