...high idle implies a cracked/open vacuum hose to the MAP sensor or the throttle body sensor may be bad. Please have both checked and let me know what is found and then we can go from there good ...
...Position Sensor (CKP). What size engine? 3.0L, 3.3L 3.8L? For a 3.8L: The Camshaft Postion Sensor is located on the top of the timing chain cover on the front of the engine on the right side of the ...
...throttle position sensor located in throttle body). Both codes are TPS voltage out of range (low and high) If you get both codes at once, then : TPS may be defective, wiring to TPS may be shorted to ...
...Throttle position sensor. I would remove this and wipe the eye with a dry rag and inspect to make sure it is clean. This is located on the throttle body and it should have an electrical plug going to ...
THROTTLE POSITION SENSOR LOCATION DODGE GRAND CARAVAN LOCATION On the throttle body where the cables are theres a spring that closes throttle body opposite side of cables look for where your air ...
Question about 2000 Caravan
throttle position sensor on my 2000 dodge caravan located ON THROTTLE BODY 3 OR 4 WIRE CONNECTOR. THERE ARE2 SENSORS ON THE THROTTLE BODY ONE IS KIND OF LONG AND ROUND THATS THE IAC (IDLE AIR CONTROL)
...position sensor at the throttle valve on the engine. You have a problem somewhere in the system. What you need now is the dealer to troubleshoot the complex system and find out what is happening that ...
Question about 2003 Caravan
...throttle position sensor now my car still does the same thing. And now the van runs better with the map sensor unplugged and the computer still reads map sensor but still bucks and stalls out ...
Question about 2003 Caravan
Throttle Position Sensor (TPS) is mounted to the side of the throttle body and connects to the throttle blade shaft. The TPS is a variable resistor that provides the PCM with an input signal (voltage)
Question about 2003 Caravan
...throttle position sensor located on a 03 Dodge Grand caravan 3.8l Disconnect the negative battery cable. Remove the electrical connector from the Inlet Air Temperature sensor. Remove the air cleaner ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions