Questions & Answers for: Lexus ES 300 throttle body

...throttle body. It is the 2" by 2" plastic protrution from the air intake tube. There should be two philips screws holding this in. Remove the two screws and back the entire MAF out. There is a wire ...

...throttle body against the firewall is the problem. However you do not need to replace it you can just clean it. After so many miles it becomes dirty and clogged. Only seems to be an issue on 2000 and ...

Throttle body has been cleaned out but problem does not go away. I also have a 2000 ES300 and I had the same problem where it would idle so low to the point of stalling and sometimes it would. Its not

...throttle body on it so what i had to do was take the large hose going straight into the throttle body sys and spray a good amount of carb cleaner straight into the throttle body and then it started ...

...throttle body how do i bring it back to 1200 rpms make sure you reassembled the throttle body properly you could have damaged the throttle body do you have a manual adjustment at your throttle body ...

...throttle body opening closing of the throttle body is there a simple solution to this problem so it don't spit and sputter and cut off Spray it with carberator cleaner to get the gunk. You ...

pedal not working while car is running and ticking noise in throttle body Throttle position sensor.

...accelerate After changing the starter and cleaning the throttle body it would not accelerate. make sure all the connectors are connected correctly, make sure you did not leave any vacuum hoses ...

...body sensor,cold start sensor and the same problem persists Cold start circuit could be plugged with carbon. Throttle body may benefit from a cleaning. Or possibly the cold (warm up)

...with my foot on the gas. Any ideas would be appreciated, thanks. Adjust the rpm, near the throttle body. Or clean the throttle body. If neither of those work, look into the idle air control