Questions & Answers for: Jeep Grand Cherokee how to thread pulleys

...thread new belt on. Simple. Hi Don, It's easy and you won't need a prybar. Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar. For putting the belt on: Get the belt around all the ...

...resulting in the fan belt breaking. ok. any tips for removing the center bolt an is it left hand thread/contra thread????? the gearbox is auto so trying to remove the bolt results in engine

Replacing tension pulley I have a new tension pully, but I can't move the old one. It just keeps tightening the bolt on the pulley Some are left hand threaded

...out the bolt and replace with another bolt. This can get rough to the point you may have to re thread the bolt hole. Good ...

...thread into the front and rear. (2) How do I adjust (loosen) the torque on the 1995 pulleys to install the new serpantine belt? It appears that this might be done at the power steering pump but other ...

...pulleys. Fan belts can be replaced without removing the engine. 1) Get the new belt. 2) Locate the tensioner pulley and retract using the appropriate wrench. 3) Thread belt onto pulley's as shown on ...

...Thread the new belt onto the pulleys in the same way the old one was on. Allow the tensioner to push on the belt once again, or tension the belt by moving the alternator or power steering pump, if ...

How to remove fan on a 5.2L engine Hi, 5.2L Engines Disconnect the negative battery cable. The viscous fan drive and blade assembly is threaded into the water pump hub shaft. Remove the fan drive and ...

i have a 94 grand cherokee, the bearing went out on the upper idler pulley. my question is are these standard or reverse threads on the bolt holding the pulley on and any tips on breaking this bolt ...

...mind breaking them) and giving the handle a good whack I believe most all are normal right hand threads hope this helps sound kinda caveman but if you dont have an impact or cant get one in there ...