Questions & Answers for: Pontiac how to thread pulleys

...should be a torx socket that fits it pretty well. as far as being lefthand thread, I think that those are normal threads. usually its the idler pulleys on fords that have a lefthand thread

...the tensioner. I did one on a four cylinder last week. The belt pulley on that one had a left hand thread. The tensioner itself should be right hand thread. Good luck. hello, I changed mine and had ...

...7. Install the new water pump gasket, then install the water pump into the housing. 8 Clean the threads of the water pump mounting bolts and apply a small amount of a medium strength thread ...

...need a Sepentine Belt tool or just a 5/8 socket & wrench to release the tension in the pulley. Thread the belt according to the chart and press the pulley down TOWARDS THE WINDSHIELD and you ...

1997 Pontiac Serpentine belt tensioner pulley wore out. How do I replace it? Using a socket and breaker bar take the tension off of the belt so you can set it aside. Then take the retainer bolt off ...

is the bolt attaching the crank shaft pulley RH of 93 sunbird 4 cyl OHC is the bolt attaching the crank shaft pulley RH or LH threads counter clock Wei's is of

...borrow, rent, or buy a puller cheap at AutoZone, JC Whitney, or Harbor Freight. There usually are threaded holes in the damper for that purpose. Put nut or bolt back on loosely so no thread damage ...

94 sunbird 2litre Is the bolt holding the drive pulley to the crank shaft, right hand thread or left hand thread? Righty tighty and lefty loosy..Right hand threads

is the tensioner pulley reverse threaded on a 2001 pontiac Bonneville? See which way the belt moves on the pully. If it goes right. the bolt will loosen left. If it goes left, the bolt will loosen ...

...have to drill out the remaining portion of the bolt. If you can get it out without damaging the thread in the block, just use new bolts. If you damage the thread, you'll have to install helicoils ...