Questions & Answers for: Mitsubishi how to thread pulleys

broken crankshaft pulley bolt on mitsibushi pajero 2.5td 1993 rhd automatic.how to remove easily the broken part which is in crankshaft,pulley is off The only possibility I can suggest is that which ...

need to replace pulley for serpentine belt on a 2000 Eclipse the bolt that connects the crank shaft to the serpentine belt pulley - is it right hand threaded or left hand threaded left need to use a ...

Crankshaft pulley bolt broke. How do i get it out???? I was attempting to take off the crankshaft pulley to put in a new seal and i broke the bolt that holds the pulley to the crankshaft (the pulley ...

Broken crankshaft pulley bolt on 99 Ford T-bird How do i remove the broken bolt You will need a very hard drill bit, preferrably reverse thread, and drill it out, and use an easy out to remove.

is the lower pulley bolt a left or right hand thread on a 97 mitsi legnum 4g93 engine? normal right hand thread. You wont find anything on that particular engine that is left hand thread. Some of them

...reinstalling the pulley you'll need to re-tension the belt. After which there should be a nut that threads on to the stud that holds that pulley in place, simply tighten this nut. I hope this may ...

...in a groove on the crank and locates into a groove on the pulley. If you put some locktite on the thread of the pulley retaining bolt you should only need to pull the bolt down to around 60 to 80

...and came off. Do I jut need to purchase a bolt and tighten it back on as well as the belt? If the threads are damaged yes. Also check the thread where the bolt goes in. Make sure there is no other ...

...the 2nd time I put 200 miles and it just did it again. I don't know the cause, but did you put thread locking compound on the bolt threads? Try Loctite red, high

...belt off

the bolt holding the tension pulley bolt to the tensioner might be right direction thread undo

you can hit out the bearing and get a new bearing
for the existing pulley ...