Questions & Answers for: Mazda how to thread pulleys

...stop undoing it keep turning it until its fully out and off as they are often treated with loctite thread lock compound and will go tight again if left partially undone good ...

on a 1989 mazda 323 how do I get the timing belt off the bottom pulley? DO I HAVE TO REMOVE THE PULLLEY? Correct - please refer to the thread " how to change cam belt" posted on "fiat 124".....

I am rebuilding the 2.3 in an 2005 mazda tribute. How do I synchronize the crank with the cams ? There is no keyway on the balancer If you have the cylinder head off it is easier to do but with the ...

...attention to the lengths & locations of the bolts being removed (make notes) as well as any thread size differences to be sure & replace them exactly where they were. Fill the system

...No part there, but there never seemed to be a part on the boss for a tensioner pulley. Bolt threads were clean with no evidence of a bolt. Mechanic installed a short belt on a new water pump ...

...the clutch right hand, (right to tighten,left to loosen)? 1993 navajo You mean standard or reverse thread?Usually crank nuts are reverse thread in relation to the direction of the pulley. So if the ...

...left of the tensioner shock. The Tensioner shock is just above the smooth tensioner pulley. All the threaded pulleys' (Drive, A/C, and alternator are within the serpentine belt, the tensioner pulley ...