Questions & Answers for: Ford how to thread pulleys

...with a specific tool and it work wonderfully. I also purchased the installer, which is susposed to thread into the shaft of the power steering pump and press the pulley back on. Only problem is that ...

could someone tell me how to remove the fan clutch on 88 bronco 2 i know the fan clutch has left hand threads but i can't lock the pulley to break it loose any tricks? Leave the belt on, and put a ...

is the crankshaft pulley aright or left handed thread 1998 ford ranger 2.5L 2wd. I'm replacing the timing belt and need to know if the crankshaft pulley is right or left handed thread. The bolt in the

...the idler arm pulley by means of a large bolt in the center of the pulley, usually reverse threaded. Pulleys cost about 10 bucks, but good bearings don't come

can not get the serpentine belt on once threaded through most of the pulleys, pull back the tensioner to gain slack, the last pulley is the smotth half moon pulley with no edges on it. any other way ...

how remove 1966 Ford Mustang 200 cu.in 6-cyl. crankshaft pulley how to remove 1966 Ford Mustang 200 cu.in 6-cyl. engine crankshaft pulley? In particular, is the 13/16'' center bolt normal threaded or ...

replace alternator Remove or disconnect the following: Negative battery cable Right front wheel Right fender splash shield Accessory drive belt NOTE The crankshaft pulley retainer has left-hand ...

...pulleys, grooved and smooth. The smooth part of the pulley goes against the smooth part of the belt. And the grooved part of the pulley goes against the grooved part of the belt. Just thread it in ...

...puller, that grab's on the raised lip on the center of the front of the pulley,the puller has a threaded shaft that presses against the center shaft of the power steering pump while pulling the ...

...clutch. I looked at the new water pump, and know that the fan clutch screws on, and is a left hand thread. I left the belt on while attempting to twist of the fan clutch to try and keep the pulley