Questions & Answers for: thread jamming

...fine, but the balance wheel is completely jammed rigid. I've looked at the shuttle and there are no thread jams at all. The needle moves fine from side to side with different stitch selections, but ...

bobbin thread jam a thread is jammed in the bobbin compartment. it broke off and i can't get it, can't really see it, but my entire machine is now jammed. i'm desperate. You can remove the thread jam ...

...my upper thread keeps knotting up, jamming the machine. how do i fix this? does it jam up on the top or bottom?? if it shows on top it is the bottom thread if it jams on the bottom it is the top ...

...machine gears jammed. My sewing machine jammed last night. Error message E6. The manual said the thread was jammed. I took it apart but never found a thread jam. I oiled it and tenderly put it

the thread jams in the hook area. I've removed it according to the manual and it still jams. change the needle clean under the needle plate where the feed dogs are for lint clean the bobbin are for ...

...cotton my machines' motor jams and the LCD screen indicates an E6 error witch means the thread is jammed somewhere. However when I look there is not thread jam. a part of the computer is ...

thread jamming between thread spool and needle believe it si jamming somewhere between the thread spool and the take-up lever. will run for about 5cm then jams. thread is split when pulled free. check

Thread keeps on jamming under the metal plate below feed dog, and fabric will not move. Tried changing needles, thread, re threading etc...but to no avail. The fabric will not feed through, and jams, ...

...jamming If you mean that the needle has jammed with a build up of thread, then the only option is to cut the thread, raise the needle, if you can, and remove ALL pieces of cut thread. Sometimes if ...

...jamming? Bobbin thread is snagging after 4 or 5 stitches. "jamming" Is typical when bobbin thread has escaped the case tension spring. Are you sure its the bobbin thread? Loop and nesting on bottom ...