Questions & Answers for: thermo sensor Water Heaters

...sensor will prevent the main gas valve from opening up and allowing gas to the main burner and will prevent the pilot from STAYING lit. A bad thermocouple indication is the pilot will light while you ...

...thermo Michael, The thermocouple sensor may not be in the best position to sense that the pilot is lit. Adjust the thermocouple mount or simply bend the thermocouple "wire" so that the pilot flame is ...

...thermo-couple its the flame sensor,you failed to give me the model number of the heater.when does the pilot go out.If its when the gas valve opens its the sensor. Open following link to identify ...

...thermo couple. If I power it off and wait 5 minutes it will usually go the second time.. any ideas? Flame sensor could be dirty which would explain why it sometimes comes back on after reseting the ...

...thermo cut-off, same prob, I have checked the alignment of the sensor and cleaned all contacts. I also did a resistance check on the sensor and it changes with heat. Any help is appreciated Have you ...

Pilot flame is not large enough to contact thermo couple Before calling service technician, open following link for Bosch troubleshoot resources, including manuals and Bosch contact information: http:

...thermo-couple ! the screen is inside the burn chamber You probably have a bad flame sensor. The flame sensor detects if the pilot is lit or not and delivers gas to the pilot. If the flame sensor is ...

...thermo couple surfaces with some steel wool... Both where the flame contacts the sensor, and the electrical contacts. Even a small increase in voltage may be enough to hold the pilot valve open. Both ...

...thermo sensor, the led light at the bottom lights up and the main gas valve opens, providing gas to the main burner which is fully ignited. At this point it's possible to take a shower, until the ...