...remove the screws holding the panel on. Inside, you will find at least one fuse. You will also find thermo sensors. They are black, about the diameter of a dime and 3/8 inch thick with two wires ...
...thermo sensor....black, diameter of a dime, 3/8 inch thick with two wires coming out. It should be continuous. Usually, it is located on the oven wall in the keypad area. You can short the wires to ...
...clip between them and tape it up. Briefly turn the unit on. Replace if it works now. The thermo is generally clamped to the wall of the oven behind the key panel. Never run without the thermo
...there are fuses and a thermo sensor. Either may be bad. The thermosensor is about the diameter of a dime, black and 3/8 inch thick...attached to the wall of the chamber. All should have
Question about GH7155XHS Microwave Oven
thermo cut out when it is on for a long time it will cut out cool down and should be ok to use again If you cook something too long, especially an item that will generate a lot of heat and steam
Question about WB27X1127 WB21X535 THERMO SW-TCO SENSE TEMP
Blown thermister overtemp sensor The sensor I have is marked KDS201. Below that number is the stamped 127. Closest I have found is number listed above. Can you tell me if this is the same part? Where ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions