Question about GDS80904BNA Open Flame Heater
...down completely. One of two problems are happening here, your flame sensor is bad, your thermo pile or thermo couple is bad, or last is that the cap on the flue is blocking the exhaust from ...
Question about GDS80904BNA Open Flame Heater
thermo and back up it will retry to restart and it will usually work and ignite. What could be causing this issue? Hi, I would have to assume your igniter is weak or has a crack in it. Do you see glow
...get 24V usually. problem is intermittant, wiring appears good, no kinks, or fraying. bypassing the thermo sensors for the 24v supply to the gas valve does not change the problem. I do have 24v from ...
...thermo it will light until the next heat cycle , then it will start all over again ----sometimes i can get a few hours of cycles out of it , other times just 1 cycle----the unit is 2 years old and i ...
...thermo stat to heat and the sequence that happens is. 1) Hear click and the motor kicks on. 2) Hear click and see he ignitor glow. 3) Hear click and the gas is opened, can hear the gas. 4) After a ...
Usually answered in minutes!
1,056 Questions
416 Questions
195 Questions
147 Questions
138 Questions