Questions & Answers for: Ford thermo sensor

...thermo stat,old one nacked .Found one linkage on the vacuum operated dash pot(?) not connected put it back to where assumed it went still no joy in the morning. Can you give me any ideas what to look ...

...thermo housing. whats up? did you check to make sure everything is plugged in like for instance the tps(throttle position sensor)? did you plug the temp sensor(it's on the intake near the thermostat ...

...the motor cools . It sounds like the thermo sensor or fan relay has gone bad.You'll find the sensor on the radiator,there should be a relay box in the engine compartment the relay should be in

...sensor into lower housing The best way is to have it up on a rack, and even then you'll contort your body and arms into weird positions. You could always remove the thermo housing.... ...

...a short in the wiring harness , check the trans temp with a laser pointer thermo gun before you leave and then after a drive , or when it goes haywire . sounds like a bad sensor , or may be a sort

...thermo fan in my 1994 ford econovan I don't think they have a fuse. You have to replace the temperature sensor for the fan to work. If that's not the case, the clutch on your fan is bad or it is not ...

...thermo in it please help You have an Electric cooling fan. Most cooling fans have 2 speeds and if the high speed is not working, eventually the low speed will not keep up and you will overheat. The ...

would lean more towards the sensor. The sensor controls when the thermostat opens and closes by reading the temp of the engine. The sensor is located somewhere around your thermostat or thermo housing

...sensor, thermostat, antifreeze, spark plugs, motor oil, reaching $900.00. Could it be the exhaust pipe system. Don't know going crazy! Have you checked the thermo fans are cutting in and out. ...

...thermo sensor that activates the fan might be bad when the engine over heated. It is usually in the cylinder head or the thermostat housing or the engine block. Pretty sure it is in the cylinder head ...