Questions & Answers for: thermal fuze Freezers

...If I do need to replace a part, where is good source for the parts? The click your hearing is a thermal cutout that is kinda like a little breaker, it gets to the temp that it is designed for and ...

...assited, clear and clean if necessary. failing that air probe might be dodgey condenser fan ? or thermal over load on ...

I turn freezer on and I hear a buzzing for a few seconds then it quits. It sounds like when the compressor is trying to start the thermal overload cuts it off. The compressor needs to be tested.

...is a bad fan. If you do not get a voltage test the thermostat. If it measures zero ohms short the thermal switch or if it is a short open one lead. If the fan works replace the thermal

the freezer is pluged in but is not freezing the fuze is ok and i hav had in in all night but its not freezing at all Is your circulating fan working? Sometimes they stick and need a shot of WD 40 and

fuze temporarily. It's back on, but system is not cooling. where is the reset button? Model: MSB2354AR Hi and welcome to FixYa. I am Kelly, There is no reset button. There is a thermal overload on the

WestingHouse frost free freezer alarm light is on freezer not working. have your thermal defrost elements checked please let me know if you need further assistance

the freezer turn on when you plug in then run for 5 sec. then stops If the unit is a few years old, then the compressor is faulty, and the protective thermal cutout is operating.

compressor comes on for about 3o seconds then trips off possibly thermal overload located @ compressor wiring... this is normally due lack of refrigerant back to the compressor from low refrigerant or

...If compressor is running, have you given it enough time to recover? or you may have a faulty thermal protector on the compressor. Cold control setting on right