Question about S129 - Starter Solenoid Switch, D984
...Solenoid.: 1. pull in test 2. hold in test 3.Return test I have found where the pull in test is weak. The coils resistance appears to be Ok 1.8 and 1.4 ohms. I found this out the hard-way. Since ...
test lamp to SCB solenoid harness connector. Cycle SCB driver in PCM by Output Test Mode. Test lamp cycle on and off - SCB solenoid is suspect. Test lamp always on - SCB signal short in harness or PCM
...Test Pin 47 (EVR) and EVR circuit at the EGR Vacuum Regulator solenoid vehicle harness connector. Is resistance less than 5.0 ohms? Yes No GO to HE113 . SERVICE open in EVR circuit. RECONNECT all ...
Question about 2000 Grand Cherokee
...Solenoid or the test can be done with the Engine running.Wiggle the Wiring Harness from the Solenoid to the PCM.Note: You are attempting to set the code.With the DRB, read DTC's.Does the 3-4 ...
...test/inspect the AIR solenoid valve outlet pipe, exhaust manifold, and cylinder head for a restriction.This issue and its repair may be under GM warranty. I think it would be worth your time to check ...
solenoid Pink wire, test at the ENG 1 labeled fuse. 5. If the fuse is B+, test at the under hood fuse block C3 32 cavity Red connector terminal F3. Should be B+. 6. If terminal is B+, trace and repair
Question about 2001 Blazer
...test my 99 honda solenoid while it attached to my car? Is there a trick to removing Honda solenoids? I may need to remove my solenoid from 99 accord lx 6 cyl this has a separate solenoid from the ...
...solenoid. Connect a test lamp between the voltage supply circuit terminal A and the control circuit terminal B. Command the EVAP canister purge solenoid valve to 50 percent with a scan tool, or the ...
Question about 2001 Blazer
...test the solenoid by connecting the multimeter to the positive and negative terminals of the solenoid, and then applying power to the solenoid. You should hear a clicking sound, which indicates that ...
Question about 2001 Blazer
...test the solenoid voltage supply circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the solenoid. Ignition ON, connect a 10A fused jumper wire between the ...
Usually answered in minutes!
627 Questions
549 Questions
535 Questions
166 Questions
208 Questions