Questions & Answers for: Samsung how to test relays

...TEST GOOD NO LOAD.THE RELAYS ARE SEALED.I AM LOOKING TO ELIMINATE THESE PROBLEMS BY CHANGING THE PCB IF I CAN FIND ONE.CAN YOU TELL ME WHERE I CAN ORDER ONE?ANY OTHER SUGGESTION ABOUT THIS ...

...tv I can hear a relay click then the stand-by led blinks 9 times. I am getting voltage on the VS test point but not on the VE test point. Any help would be great. Thanks Try the following steps:

...two hours and plug it in. If you hear it running, a problem is causing the compressor to overheat Test the temperature control Test the evaporator fan Test the defrost timer Test the compressor ...

relays you may encounter, wire coil and solid state. If the relay has an exposed wound wire coil it can be tested for continuity. Otherwise, the relay is of solid state design and requires specialized

...test each output to see if the power supply is causing my problem tv goes click click click. There are 2 relays on the power supply board what is each relay for. One of the relays never has voltage ...

...on the run prong, now take note of the reading example 9 ohms. Now match the total of this ohms test with the total of ur two separate test. 9 ohms, if they match ur ok give or take 5 percent

...the new board. When I bypass the number 3+4 post of the logic board the screen comes on with the test colors but again turns off after about 6 seconds. I don't see or feel any popped capacitors

samsung plasma tv Model PN60E8000GFXZA not turning on just clicking, tested standby dc volts on power board and was at 5.46. thought it might be the board this connects to. no capacotors damaged Check

...right side of the D/W. A metal panel/shield (on the right side) must be removed to gain access for testing. Testing the HEATING ELEMENT *can* be done from the bottom/front---but is easier if the D/W ...

Samsung front washer WF203ANW will not drain. The drain hose is not blocked. Will drain on spin cycle if drain hose is laying on the ground also have tested the pump and it runs if I put power to it ...