Questions & Answers for: test a ptc

...again. then test the resistance of the ptc starter, it should have a reading between 20 ohms and 100 ohms. and there whould be no rattling sound inside the ptc starter. hope i was able to

...ptc. If all items check out according to the wire schematic in the console suspect timer as having open contacts. The motor switches will have to be tested according to the test on the tech notes and ...

...PTC relay. TEST compressor start before installing cover... PLUG in unit After the test unplug the unit... reinstall the plastic cover and wire clip. Reinstall back panel Return unit to service. ...

test to see if the compressor is shorted internally. The PTC and Thermoal overload are removed from the compressor terminals and you red from pin C to the other 2 terminals and then to the case of the

...Test compressor resistance while PTC and thermal overload are removed. Tech will read terminal R to terminal C and terminal S to terminal C (winding checks). Then the tech will read R, S and C to ...

PTC overload relay on the compressor body or a bad compressor itself,you can test the compressor with an ohmmeter between the 3 terminals on the side of the compressor PTC is mounted,if its ok then it

...ptc overload/relay off the compressor and take an ohm meter and from the single pin on the compressor to each terminals above or below the single pin test these one at a time they should each resd ...

test. Either PTC readings reqd or conformation of this fault. Thanks. Dennis Usually if this model stops after approx 3 secs it is an invertor or mag fault. Check that the aerial cover is clean Page 3

...is the starter relay for the compressor 253 52342301 how do i get the above part out and test it? It is the starter PTC for the compressor. Best answer ...

...test ok for a closed circuit but may be flawed as far as the current BEING put out? all fridges are and have different ohms ratings for the thermistors and there are some which are called NTC ( ...