...on. Press and hold down the POWER button. While holding down the POWER button, press the RESUME button eight times. Release the POWER button Press and release the POWER button to terminate the
Question about X3480 All-In-One Printer
...button test. 5. Press the up arrow (Up arrow button) twice. The screen will display Single Test Page. 6. Press the Start button once. The self test will begin. The printer will stop once the page has ...
...button. The self-test should at least print out a set of either black or color bars, if not both (if you have a printer with both color and black installed simultaneously). Should this test fail, ...
Question about X5470 All-In-One InkJet Printer
...Test Page?. 8. Press the check button once. This will start the Self-Test. Once the page has printed, the printer will stop. The test is not continuous. The self-test should at least print out a set ...
Question about (PSS26MSRSS) Side by Side Refrigerator
...button to begin the test. First, run the control and thermistor test: Control and Sensor System Self-Test (0 7) This test checks all five thermistors located throughout the unit. Once the test is ...
...button) test to determine which button is at fault. Carefully free the and perform the test again. If button is free but the key struck code still exists then you'll need to replace the electronic ...
hold down the Paper Feed button, press the Power button ONCE. When the Power button begins to flash rapidly, release the Paper Feed button. A test page will print.Trust this is helpful. Please vote. :
...button to begin the test. When testing has been completed, do one of the following things: ? Enter code 1 5 to completely reset the system. ? Enter code 1 6 to exit diagnostic mode. The temperature ...
...test, press and hold the Power button while pressing the Cancel button eight times. Press the Resume button four times then release the Power button. The printer will generate a series of noises then ...
Question about HSS25GFT 25.0 Cu. Ft. Side-by-Side Refrigerator with GE SmartWater Filtration, LightTouch
...button to begin the test. When testing has been completed, do one of the following things: • Enter code 1 5 to completely reset the system. • Enter code 1 6 to exit diagnostic mode. The temperature ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions