Questions & Answers for: test abs

TEST THE CODE WAS B1342 ABS MODULE, THEN IT WAS TEST DROVE & EVRYTHING WAS OK BUT WHEN I DROVE IT ALL THOSE LIGHTS CAME BACK ON & ARE STILL ON, ....REPLACE ABS MODULE???? MAYBE, I DONT KNOW ..

Ad

Question about 2004 Explorer

1 Answer

...ABS. Testing and changing the faulty relay can fix the problem. If light turns off on startup, and comes back on when you reach some speed, usually you need to check the wheel sensors. You test them ...

Ad

Question about 2004 ION

1 Answer

...test ABS. if it sink at this point the fix is a new abs module.Here the thing if you replace the module it will have to be flashed , the engine management will not communicate with it or recognize ...

Question about 2002 Explorer

1 Answer

ABS light came on. Put on all new breaks. ABS light continued to be on. Was tested 2 times at Auto Zone and I tested with my meter. There was no code found. Disconnected battery and it did not reset. ...

...of the negative cable may or may not be the cause, the ABS module must now be tested for fault codes, this is done with a special scanner, any good brake shop or tire shop can perform this

Question about 2006 Crown Victoria

1 Answer

...ABS self-test. If any DTCs are retrieved, REFER to the Anti-Lock Brake System (ABS) Module Diagnostic Code (DTC) Index. If no DTCs are retrieved, CARRY OUT a drive test above 15 km/h (9 mph), then ...

Question about 2000 Expedition

1 Answer

test. C1095 ABS Hydraulic Pump Motor Circuit Failure ABS Module Go To Pinpoint Test D . C1145 Speed Wheel Sensor RF Input Circuit Failure ABS Module Go To Pinpoint Test E . C1155 Speed Wheel Sensor LF

abs codes can lead to a pinpoint test. once codes are read, there may be a specific area indicated to run tests. since the wheel hub area was where the recent work was performed...i suggest looking at

Question about 1996 Legacy

1 Answer

...test a abs sensor I fixed wires going to sensor but light stilll on dash . Can I test the rear ABS speed sensor to see if it is connected Here's a youtube link that you can use to test the ABS sensor ...

...ABS module calibration. Test Step Result / Action to Take P1 CHECK FOR DTCS Connect the diagnostic tool. Key in ON position. Retrieve DTCs. Is any other DTC retrieved with C1998? Yes GO to the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...