power vent 50 gal tank flashing code 2-3 1. Turn off power vent blower and set water heater temp to vacation (lowest temp) 2. Turn on power vent blower 3. Turn the water heater temp from vacation ...
after water gets to temp. ,pilot lite goes out after water gets to temp. a few minutes go by I hear a click and the pilot light goes out replace themal couple
Question about 40 Gallon FVR NATGAS Low WATER HEATER 6YR 22V40SF
...s a dial on the front (probably red) and it will have settings on it. A B and C. Turn up to desired temp, but be careful of faucets if there are children in the house. Good luck If you turn up ...
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
I the mode switch will not change it to heat it shows the temp but the mode switch will not change it to allow to turn on the heat see if on remote if ok check temp sensor
Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm
...within in minutes. I have a Rheem tankless water heater and it heats up initially to the proper temperature and the cools down immediately. I did the visual check the burner is staying on. Is
Question about M206A 206K BTU Pool and Spa Propane Gas Heater
...heater will not fire has code #sns what is the problem? the water is 65 degree. SNS means the temp sensor is out of acceptable range. Could be the following: 1. Water temp is below 36 degrees F ...
need to up water temp in a 50 gal rheem 82v52 electric no dial obvious The two blue rectangular cover plates, held on by two scews, cand be removed by taking out screws. There might be a little piece ...
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
...Cfh is call for ?? heat. That is Not an error code. As stated earlier, = Call For Heat When water Temperature falls 2° lower then Set Temp, a Heat Demand is triggered, and the heater should fire to ...
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
Rheem pool heater displays SNS. What would cause this to be displayed? The air temp is in the twentys and the water temp is in the thirtys. Two month ago it was fine showing the temp but now I can not
Question about 266K to 399K BTU Swimming Pool Natural Gas Heater ()
rheem hot water heater says set temp? no hot water If it is a gas water heater you must set the temp on the gas valve. Press the two outside buttons until they flash. Now you can use the arrow button ...
Usually answered in minutes!
335 Questions
250 Questions
267 Questions
222 Questions
190 Questions