Questions & Answers for: Chrysler 300M how to tell if gear

gear. getting a "0700"fault code. is this in the computer or something with the transmission itself? The 700 is the limp mode, as I recall. One or both of the sensors are failing, and they are not too

...gear,please tell me what sensors are that should be replaced??please..... thanks... When a chrysler overdrive goes into second gear it indicates there is a problem There is no way to tell you what it ...

gear at the transmission. Then have either the shift linkage or the dash indicator cable adjusted to be accurate. But whether or not your transmission is working right or not we can't tell. If you are

...Thank you. It shoul be in park and up to operating temp. to check the fluid. There is a sensor that tells the tranny when to change gears. Usually the problem with them is overdrive. If the the fluid ...

tell me my car is ready but I am now having a transmission problem it wont come out of 2nd gear? I have never had a transmission problem at all, I drive 60 miles to work everyday, now I seem to have a

...tell me car was ready, but my transmission was not coming out of second gear? I have never had a problem with my transmission at all! I drive 60 miles to work everyday. Get in my car and the auto ...

gear that allows the engine to run at the speed of peak efficiency when the car is cruising at the speed it will be doing for much of its life. Here in the UK we have a national maximum speed limit of

...That indicates the transmission solenoid is bad. Miles on car is 265,000. P0700 is just the TCM telling the PCM to turn on the check engine light because it sensed a problem in the transmission. ...