wont come on my tv will not turn on it will blink several times a red light but not come on, what should i do? Same here. Purchased the 42" on Nov 07 Model TH-42PX75U. it won't turn on either and the ...
...if you found a solution... sounds like my TV has the same failure. thanks This could be 3 different things and needs to be taken care of by an authorized Panasonic technician SU Board, SD Board, ...
Question about TH-42PX75U 42 in. Plasma Television
SCREEN WENT BLANK, POWER ON INDICATOR LIGHT FLASHES 7 TIMES GOES OFF FOR A FEW SECONDS AND REPEATS. SU OR SU BOARD BAD NEED REPLACED TH-42PX75U PART: Manufacturer Panasonic Part NumberTXNSD1HNTU ...
Question about TH-42PX75U 42 in. Plasma Television
I had the 7 blinking lights problem after tv shut I had the 7 blinking lights problem, after tv shut off it came back on stating "error occured problem fixed. 5 minutes later tv shut down and wouldn't
...SU / SD / SS Boards (SC floating voltage area) 8 blinks Driver SOS 3 SS Board (SS energy recovery circuit) 9 blinks Panel Config. SOS 10 blinks Sub 5v SOS / Main 3v SOS DG Board DTV 9v SOS / Tuner ...
Question about TH-37PX50U 37 in. HD-Ready Plasma Television
...SU board. (See precaution #3) Reconnect the SD board only. (See precaution # 5) Plug in the TV and turn it on. Yes No With the SU board and the SD board still disconnected, remove connectors SC2 and ...
...SU board. (See precaution #3) Reconnect the SD board only. (See precaution # 5) Plug in the TV and turn it on. Yes No With the SU board and the SD board still disconnected, remove connectors SC2 and ...
...SU board. (See precaution #3) Reconnect the SD board only. (See precaution # 5) Plug in the TV and turn it on. Yes No With the SU board and the SD board still disconnected, remove connectors SC2 and ...
...SU / SD / SS Boards (SC floating voltage area) 8 - blinks Driver SOS 3 SS Board (SS energy recovery circuit) 9 - blinks Panel Config. SOS 10 - blinks Sub 5v SOS / Main 3v SOS DG Board DTV 9v SOS / ...
...su board or all 3. Disconnect the ac cord. remove the back cover. on the left are 2 thin boards with flat cables that connect to the panel. these 2 boards are the SD and SU boards. They are connected ...
Usually answered in minutes!
300 Questions
174 Questions
154 Questions
131 Questions
120 Questions