sensor. What it does is watches your Crankshaft for TDC (top dead center of the #1 piston) Then Ignition timing can occur because the ecu knows where the #1 piston so it can squirt fuel and ignite the
...sensor from the lower left side of the engine block. Make sure the engine is at TDC and install the threaded crankshaft holding pin Tool No. 3242 and lightly tighten. Remove the upper timing belt ...
...TDC of each cylinder. The sensor uses a permanent magnet, core and coil. The changing gap causes the magnetic field near the sensor to change. This in turn varies the voltage signal to the ECM. The ...
...sensor g28 is on the side of the block. The flywheel have offset bolts so can only be fitted in the correct position. The best way to set tdc is with a special tool that goes into the side of the ...
...sensor g28 is on the side of the block. The flywheel have offset bolts so can only be fitted in the correct position. The best way to set tdc is with a special tool that goes into the side of the ...
Question about 2002 Passat
...sensor g28 is on the side of the block. The flywheel have offset bolts so can only be fitted in the correct position. The best way to set tdc is with a special tool that goes into the side of the ...
Question about 1999 Passat
sensor is telling it that it is on the TDC of the intake stroke it want let anything happen. If the cam is not where it is suppose to be when you turn it up to TDC, say is is holding a valve open then
Usually answered in minutes!
1,322 Questions
1,089 Questions
831 Questions
844 Questions
677 Questions