Zoom 9030 works well after all these years there is a memory battery that needs to be changed every 5 years or so. The only problem is when I plug in the 8050 foot controller it won't change any ...
Need a 6 pin cable for Roland JX-3P I need to replace the 6 pin cable that conects the jx-3p to the pg-200 but no one around here has one. Any ideas? Make your own cable! Check this connector or ...
Question about Ct100 Cable Tester
Beringher CT100.. X Pattern on LED grid when testing an xlr cable Hey all, Im using a Beringher CT100 cable tester and I'm a little confused with a reading im getting from acouple of cables, Im ...
...Pin one is ground and pins two and three are soldered to the positive. I used shielded cable and the shield is soldered to negative on the RCA jack but left unconnected on the XLR jack. This prevents ...
Broken coder pin..where does it belong inside Coder pin? Never heard of that... do you mean Cotter pin? They go through holes in shafts to lock collars to shaft, etc. SOMETIMES they are actually used ...
i have the PL400 stand and cannot open it. there is the long pin but it won't budge, Can you help The pins can be sticky. You squeeze the pin extending out upward toward the top cross member to ...
Question about Proline Pl 400 Double X Braced Keyboard Stand
cs4080 does not turn on the yellow jight comes on ang nothing else there are no voltage on tp/11/tp30/tp31/tp32 r417/r217 has 24volt on one side and the other side has no voltage the resistor is goo ...
Question about Proline Pl 400 Double X Braced Keyboard Stand
My frontman 15r has power but no sound Has power but no sound from anything what so ever Check to make sure the problem is not with the headphone jack or the external speaker jack as these are in the ...
Question about Acoustasonic Telecaster 3TSB
battery drains quickly - The jack acoustic side does not turn off when guitar cable is removed It's possible that the socket loosened and rotated creating a short between two pins. Remove socket and ...
repair Help Powered Mixer turns on,has but no output.. Hi, As a test procedure check for -15V at pin 4 of one Opamp, chip of 8-pin and +15V at pin 8, if you have those then it may be your output ...
Usually answered in minutes!
297 Questions
192 Questions
155 Questions
161 Questions
136 Questions