...track. Disconnect one of your low beam head lights, turn the headlights on and to low beam, you should have voltage on the "tan"wire at the headlight. If you do not, go to the dimmer switch under the ...
Question about Thomas The Tank and Friends Track
tan curve track as shown in the picture. Then connect a half straight track, 3 straight tracks, the long sloped track to the bottom of the medium tier. It must connect to the tier at the halfway point
Question about Thomas The Tank and Friends Track
...of the spark plugs. White coloration of the plugs = too lean. Dark spark plugs = too rich. A nice tan or light brown color = perfect. Running with jetting that's too rich, or too lean, can both ...
...track by leaning out the mixture. The best way to see how close to optimum the mixtures are, is to look at the color of the spark plugs: white = too lean, black or dark brown = too rich, dark tan to ...
...for this test would be apperciated. Am I on the right track? grey/red signal return Red Power Black/*********** ground Tan/Light blue MAF signal return Light blue/Red Maf signal Grey intake air ...
to. Any fault codes? Do you have fuel pressure?If not, check relay, check to see if the tan wire in the relay connector goes to ground initially for priming. If not check harness for
Question about Sunvision Pro 24S Tanning Bed
1986 sca wolff 328sl tanning bed wont stay running bed working fine then one day I had it on but when I lowered the canopy it shut off. If I unplug it and plug it back in it will lite up then shut off
Question about 1994 Skylark
...tan wire left headlamp an lite green right side headlamp ! If there is no voltage back track to headlamp switch , which means pulling the plastic cover from around the upper steering column ! check ...
Question about 1994 Skylark
...Tan, and yes it is tied into the same wiring as in your column. If you have power at the column and no power at the solenoid, then there is a break in the circuit. A push button is normaly installed ...
Question about 1994 Skylark
...track If the other seat positions work ok, then it sounds like voltage and ground are ok. I don't know what testing you've done? The horizontal motor, to move back, lite green wire is voltage. tan ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions