Questions & Answers for: Pontiac where is the tajima degree wheel

...noise's when wheel is turned from side to side, a very small degree of rotation(10 degrees) with engin running,wheel's are turning ever so slightly, engin off, no clicking axle brgs maybe goin ...

Crooked steering wheel on 2009 Pontiac G6, serviced twice, dealer says car is in alignment altho' the steering wheel appears pitching to left a few degrees, can this be resolved? Yes it can be solved.

hum from front drivers side wheel bearing changed Two possible problems both related to that bearing change. 1. Was the bearing packed with grease before it was installed? If not, another new bearing ...

vehicle starting stalling after getting off expressway now the outside temp is 75 degrees and stalls at any speed Have you changed your fuel filter recntly? If not-do so.It is located passenger side ...

...degree curve when loud pounding sound started somewhere in the rear of car. Stopped & put it in park and revered the engine and there was no sound then. In less than 1/4 mile it started again. ...

...degree rotation maximum to install the cotter pin. Install the wiring harness to the lower control arm.Install the cotter pin (1).Install the stabilizer link to the lower control arm. Refer to ...

cant find the fuel filter Look under the drivers side between the front and rear wheels located on the undercarriage...fuel line turned 90 degrees then continues toward gas tank insert.  Hope ...

When I turn my wheels to the left and right 45 degrees past center I hear a hard "clunk" noise. I have double checked to that all the lug nuts and wheel studs are tight as well as the lock nut for the

ignition won't turn when cold outside 8 degrees outside ignition won't turn what to do Move the steering wheel to relieve tension on the lock, little to the left or right, then it should turn.

...degree of difficulty is it to change front passenger side hub 2004 Pontiac Montana also what tools will be needed Hi if you look on utube there is a vidio takeing you through the prosedure,hope this ...