Questions & Answers for: Audi where is the tajima degree wheel

What is the torque setting for the rear wheel bearing 2000 audi a4 FWD? New bolts ; 1. tighten 190 Nm with wheel off the ground. 2. lower car to ground, tighten further 180 degrees 3. tighten further ...

recode steering angle sensor For recode the steering angle sensor you must connect a diagnosis scantool to the data link connector of the car in order to access the ESP ECU (Electronic Control Unit), ...

...degree of offset. If you wheel is 15mm offset then it should always be 15mm. By fitting wider wheels the wheel not only sticks out further but also sticks in by the same amount. For example if you ...

2002 audi tt 225 bhp cranksharft torque settings Crankshaft torque settings for 2002 Audi TT 225 BHP: 1. Main bearings: Renew bolts = Yes 2. Main bearings: Stage 1 = 65 Nm 3. Main bearings: Stage 2 = ...

My engine is perfect but the power is not reaching the wheels, it is an automatic. Could it be gearbox or low oil in gearbox How to check & change oil in automatic transmission on 2004 Audi A4 At ...

degree that the wheels lean out (positive) or in (negative) at the top of the wheel in the straight ahead position. It is adjusted by either moving the top control arm in or out or the bottom arm(Ford

...degree. 5) Once all undone, a few grazed knuckles later an you should be able to wiggle/push/pull the starter motor out of the bell housing. 6) you should now be able to slide this out through the ...

...wheel;if you konow the #1 cylinder from tracing your plugwires remove the #1 plug and rotate it by hand its easier to get it exactly on tdc!! itll b a mark that says 0 it all depends on your engine ...

back wheel sqeaking and getting hot The following asumes only one wheel is hot and the e-brake is not engaged or possibly hung up from having been left on while the car was not driven for a while. Up ...

timing 87 audi 141 cid 2.3 what degree? The timing should read the same, no matter WHAT temperature the readings are taken at! Why would you think degrees would make any difference, and are you ...