Questions & Answers for: Chrysler tailgate lift support

Question about 1999 Town & Country

1 Answer

chrysler town and country tailgate lock How do you remove the lift handle from the tailgate so we can get to the lock assembly? you would need to remove the inside rear panle.

Ad

Question about 1999 Town & Country

1 Answer

...tailgate lift supports there will be either a bolt at each end or a spring slide, if it is the slide just push it along with a screwdriver and the support will just pull off. make sure to prop the ...

Ad

Question about 2001 Town & Country

1 Answer

you remove spare tire on 2001? Open you tailgate look at the carpet, you will see a rectangel cut . Lift the flap there is a nut that you need to loosen with you tire iron,and that will lower you tire

Question about 2001 Town & Country

1 Answer

Back tailgate will not lift or lower 2003 Chrysler Town and Country. Tailgate will not open or close with either control. The motor itself could be burned out

Question about 2007 Pacifica FWD New Cars

1 Answer

breaklight is out OK put a new bulb in. Lift tailgate remove two bolts holding tail light and pull out remove bulb replace bulb

Question about 2002 Town & Country

1 Answer

...tailgate will not open remotely Does it power open at all.  If not I bet its the latch.  This is pretty common on these.  Also I have seen when rust will build up on the hatch lift ...

lift the tailgate and open the back seat sliding doors. all oof the sudden it will not unlock the front doors, the sliding back seat doors, but does lift the tail gate. The unlock switch on both front

...tailgate won't open at all when I disconnect the battery. The lift gate in Pacifica has an electronic lock; so, it needs power to operate, even when you open it manually. I hope this helps you! Could ...

...lift struts can be removed by propping up the gate and prying off the strut ends from their balljoint ends. Some struts have a broad metal band that acts as a spring or retainer and you may have to ...

...tailgate and lift the spoiler free. Unclip the wires and lift the spoiler off the car. The whole light unit is held in with two bolts. Unbolt, drop it out and fit the new one. Before refitting the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...