Questions & Answers for: GMC tahoe lift gate support

Question about 1998 Jimmy

2 Answers

lift gate. It should need a 10mm socket. The remover the lift gate handle with a "star" driver. Similar to a screwdriver. Then there are 4 plastic push type anchors inside the lift gate panel. You can

Ad

...lift gate goes up about half way and returns to the closed position. What is going on? try removing your shocks/struts for the lift gate. once removed, check to see if they fully extend in and out of ...

Ad

...gate lift assists. Need to remove tail gate lift assists on 1995 GMC Jimmy. AW pretty easy to do find the ends of the lift support should have a clip on the back side of where it connects pull clip ...

Question about 1995 Jimmy

1 Answer

...lift gate .And some struts use a little push clip at each end of the strut . these you can use a pick or a small flat blade screw driver to pop out of place . the new struts should have them already ...

...LIFT GATE GLASS,THEN REMOVE WIPER ARM COVER AND NUT AT THE OUT SIDE LIFT GATE, THEN THE BEZEL.BECAREFUL DONT DAMAGE PAINT.ON THE LIFT GATE.AND REMOVE THE UPPER AND LOWER LIFT GATE TRIM ...

Question about 2008 Yukon XL

1 Answer

powergate lift gate doesn't open when i attempt to open my lift gate, it opens partially and immediately closes check the shock looking struts they hold it up the motor just lifts it up

...lift gate is open only happens when lift gate is open I would bet on the liftgate module (LGM) It controls all that stuff back there,wiper,defrost,gate ajar light,gate lock and unlock ect. Might try ...

...tahoe lift gate not opening - YouTube ? 2:12 www.youtube.com/watch?v=xU6ybiY3F4I Sep 1, 2010 - Uploaded by 76bluemoon Back lift gate/glass would not open or release. ... Wow, are you sure? .... known ...

where is the fuse for rear window defroster on a 2005 envoy? located in the back . It's called the LGM fuse #2 (Lift Gate Module) The Lift Gate Module controls the defroster grid circuit.

lift gate not working My lift gate would not work at all. I drilled the hole in the door panel and got it to open. I replaced the electric switch and the gate now opens but I have to manually lift it.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...