Questions & Answers for: Chevrolet Cavalier tacoma wheel bearing

...wheel bearing that needs replacing. However, I recently put 4 brand new tires on the car and had a front end alignment done. The noise is progressively getting louder. The mechanics that have ...

...bearing. Remove the wheel, the brake caliper, the rotor. There will be three bolts holding the hub on from the back. You will need to remove these bolts and slide the hub off of the spindle. then ...

...Wheel bearing shot. wheel bearing ? if your hub cap is off and the car is sitting on the ground, and you grab the tire and move it left to right . you should see play in the center hub if its a wheel ...

...wheel bearing because that tire was worn down really bad on the outside. I replaced the passenger front wheel bearing, and it is still making the same noise. Should I replace the driver side wheel ...

...wheel bearing or universal drive shaft coupling You need to jack your car up and check that the wheel is tight and check that the wheel bearings are not bad. The sound could be eiyher one of these or ...

...wheel bearing ,left side It may be your wheel bearing on either or right or left front tire. Put your car on jacks and remove both tires. Pull on the wheel up and down. If it moves with a clanking ...

have a steady growl up front at hiway speeds.cv boots are not cracked and no clicking.what else could this be.brakes are good More then likely wheel bearings. Make sure you check rear wheel bearings ...

...wheel bearing but it was not any ideas is it the axle im not sure the type of car or teuck this is but a humming sound from the front end is common with a bad tire or the most common is a wheel ...

...tacoma??? You might have a wheel sensor issue (part of the wheel bearing assembly) It tell the abs computer the wheel speed, and if one is bad, it will error the abs, and turn the light on. You can ...

...wheel bearing is loose or worn. Further check would be to rotate the wheel and listen for bearing noise. Jack the car up as if you wanted to change the wheel where you want to check the hub bearing ...