Question about DC07 Bagless Upright Cyclonic Vacuum
...brush roller when you pull the handle back to vacuum. Check the clutch control knob which is at the bottom left side of machine looking from the front. It should rotate to drive position when handle ...
Question about DC07 Animal Bagless Upright Cyclonic Vacuum
...switch the machine on and have a look (look, don't feel) to see if the brush roller is rotating. If it is, then the belt is not broken. Depending on how much use your machine has had, it's quite ...
...switch. When you removed the brush roller dod you examine the end of the actual roller that is opposite from the removal opening. There is a gear that the roller fits over that may have gotten ...
Question about 3750 Lift Off Bagless Upright Vacuum
...switch activated If you hear the brush moter running then the belt driving the roller has probably broken. It can be easily replaced by removing the brush plate underneath and pulling the roller out. ...
...switch may need to be replaced if it's defective. The roller brush is disabled while the handle is in the upright position, so tilt the handle backwards while testing the roller brush. I hope that ...
Question about Navigator Lift-Away Professional Plus Upright Vacuum
...roller switch is fine and light attempts to go green but goes red immediately. can't turn the roller with my hand Sound s like the brush roller is bad and or the belt is broken. Most models have ...
Question about DC25 Vacuum
...switch. If its depressed, brushes won't rotate Hello, this is Ava with Think Crucial. There are a number of reasons why your brush roller has stopped moving. General maintenance to your vacuum is ...
Question about DC25 Vacuum
...the left turns the brushroll on and off You havE a Windtunnel air vacuum cleaner. If the brush roller isn't spinning and the switch is on, you need to pull down the handle to make the roller turn
...roller brush is not turning, check the belt. If your vacuum cleaner is a Shark, the problem could be a bad limit switch located in the base of the head unit. To replace this switch, you must ...
...switch? If the roller brush of your Miele vacuum SEB 234/236 only spins when you manually hold down the switch, it indicates that there is a problem with the electronic circuit or mechanical parts ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions
