Question about 1001-BE Black Two Button Fireplace Remote with Battery Eliminator 1001-BE
i can not use my remote control... i have tried to reset it by pressing the learn button... but not sure what im doing... If you followed the Owner's Manual Instructions and it didn't beep twice, it ...
I am trying to program or override settings set by our gas supplier for our remote for model 3002. I want to be able to turn it on and off manually and it not work by thermostat mode. Can't seem to ...
Smart stat 2 fireplace remote chirps similar to a smoke alarm. batteries have been replaced twice. Chirps at the receiver which is a plug in style no batteries. The beep can be stopped for a few hours
Question about 1001-A Fireplace Remote Control On/Off
The remote no longers turns on the fireplace. I replaced the batteries. There temperature still shows on the remote but pressing "On" doesn't cause the fire to go on. The pilot light is ...
Question about 3301 Thermostatic Gas Fireplace & Gas Stove Remote Control System
...supposed to be between 1 and 3 degrees but mine was set to 9? I set the swing back to 3 and it started working just fine. Press the timer/time and down buttons simultaneously to set the swing
cant program remote I'm going to assume you are meaning that you are unable to set the "target temperature" for the thermostat? This remote control system can be thermostatically controlled when the ...
Question about 3301 Thermostatic Gas Fireplace & Gas Stove Remote Control System
...swing" temp settings are set at, as this may effect how quickly the unit shuts off because it thinks it's too close to the target temperature. If needed:Skytech's Tech Support number is ...
Question about 3301 Thermostatic Gas Fireplace & Gas Stove Remote Control System
Remote won't work unless next to fireplace. I have a skytech 3301 remote. I have changed the batteries in the remote and in the receiver. The receiver will only work if the remote is sitting right
Question about 3301 Thermostatic Gas Fireplace & Gas Stove Remote Control System
...set "THERMO SWING" can be checked by adjusting the SET TEMP 2 0 F above or below the room temperature. This will cause the system to turn ON or OFF. Normally the system will only respond to ...
Question about Remote-Control-Thermostat-1001-On-Off
skytech 1001 no learn button to reprogram. Red light works, lights the fireplace in "on" mode, but the remote won't turn on it on. Set-up (Programming) procedure is too much to type in here, and is ...
Usually answered in minutes!
20 Questions