Question about 148 GTL 120-Channels Base CB Radio
...148 won't stay on frequency, same frequency on all channels The radio when you key down keys and swings normally, just not on the correct frequency. The frequency remains the same on all 40 ...
...modulation wattage is still swinging much higher. Also, you will get more swing with a lower dead key any way, which is better if you want it to be loud. Leave it alone. its probably set just
...set. The swing should be turned up (thats why you turn VR4 all the way to the left) witch will give you just over 20 watts swing. this will drive the box good. Any where between 20 and 35 watts will ...
...set the dead key with a swing kit. you need a watt meter, preferably one that reads peak and average watts. If not, average will be find. Open the bottom cover of the radio. Hook the radio up to the ...
up on high power but talks fine on low cobra 150gtldx breaks up on high power but talks fine on low power sounds like the dead key might be set to high on the high side and you're not gettin any swing
...getting that much swing. You should set the radio so the box dead keys around 300 to 400 watts. A 2x8 has a variable on the front.. Leave your radio alone.. Adjust your deadkey to 200watts let it ...
Question about 148 GTL 120-Channels Base CB Radio
...than one watt on the ssb side..Radio has a 4 watt dead key on am and i have ajusted the radio to swing no more than 10 watt,,but cut out badly and ssb with the amp on Hi, my name is John. Adjust ...
cobra 19dx iv when i key up it swings all the way to a 9 is there any way to set swr,s without a meter Just buy a factory built antenna/(it should be close) Buy you a magnet mount RADIO SHACK ...
Question about 25 LTD 40-Channels Base CB Radio
...set a high dead key. The radio should key low and then swing high. You must first track down which one is the problem. You will need a good watt meter for that. If it isn't a problem with too high a ...
Question about Cobra25-LTD40-Channel CB Radio with Dynamike Gain Control
swing kit in my cobra 25 ltd now i have a 40 watt radio but have run dynamike all way up for radio to transmit if turn dynamike down i lose modulation pot set correctly what would cause this I believe
Usually answered in minutes!
980 Questions
274 Questions
141 Questions
137 Questions
112 Questions