Questions & Answers for: GTCO super 5

Using Calcomp 6 drawing board in corel draw and signwizard 4.1 Hi, I am using a calcomp drawing board for the first time in corel draw and signwizard. I have checked that the board is working in the ...

Super L III is not recognizing stylus Do you get 4 beeps on start-up? Is this a cordless or corded pen? Change the batteries in the cordless pen. Check the cable on the corded pen for breaks or cuts. ...

how do i adjust the tone and volume of the board. its a Super L II Plus. Somehow I turned it off with the picture at the top. After turning it back on the only tone I can get is a sharp loud tone. I ...

I have a GTCO Digi-Pad Super L tablet with a 4-button cursor. I was having a problem getting the computer to see the tablet in startup so I upgraded to the latest software. The tablet starts better, ...

...I'm using a sixteen key corded digitizer with a Roll-up III 2024 cal comp pad. The super L II has a selection on the Superset Menu to turn off the alarm. It looks like a

Relocated digitizer and when set up it peeps with message running self test no digitizer Make sure the Digitizer is set to Superset Code S01, it may also be a bad cable,check all of the cables for ...

L III? First set the Superset Code to S01 on the tablet, if you are using the TabletWorks Driver it should work in your software. Try using a Super L II selection or Digipad 5 if it has that selection

how is this hooked up and how does it work This pen will only work with GTCO SLX or Cordles Roll-Up products. Install a new battery and it should work on a SLX cordless tablet or a Cordless Roll-Up.