Question about BR-6104 Broadband Router. One 10/100M WAN Port and 4 10/100M LAN port.
...pc's are on the same ip address route (e.g 192.168.x.x), but not all the same last digit; and the subnet masks are all the same (eg
...subnet mask Leave the default gateway blank Type the ip address of the DNS server you took note of earlier into the "Preferred DNS" section at the bottom of the form. Click ok and ok and ok until ...
...Subnet Mask: 255.255.255.0 Default Gateway: 192.168.2.1 Open your browser and type http://192.168.2.1 Now login as: admin (default) and password is: 1234 (default) Click on GENERAL SETUP on Top-Left, ...
...Subnet Mask: 255.255.255.0 Default Gateway: 192.168.2.1 Open your browser and type http://192.168.2.1 Now login as: admin (default) and password is: 1234 (default) Click on GENERAL SETUP on Top-Left, ...
...subnet mask and the default gateway. Once you have the default gateway, you can connect to it via Internet Explorer. You will need to set it up as http://192.168.1.1 (where the IP address is your ...
subnet mask of 255.255.255.0. If you also want internet access you will need to set the Gateway and DNS to 192.168.2.1. Once that is set you will be able to try bring the page http://192.168.2.1 again
...when I am connected wirelessly even though it says it is connected properly check the signal strength and check the ip address change it to the same class, check subnet mask, int gateway etc and
...of your router and try to connect it. examples if your router have default ip adress : 192.168.0.1 give your computer address as : 192.168.0.2 and subnet mask 255.255.255.0 default gatway : ...
...subnet mask,and Gateway addresses of your ISP ( InternetService Provider ). According to above addresses, you have to complete the networksettings of your printer by mentioning the different IP ...
Usually answered in minutes!
8,663 Questions
6,597 Questions
5,420 Questions
5,130 Questions
4,425 Questions