Questions & Answers for: sub frame

attached to the subframe of the car. When you undo the rear sub frame bolts be sure to have a jack under both sides of the sub frame to support. The R&P is bolted to the sub frame and so is the engine

Sub frame interchange 1991 Saturn SL2 with damaged front sub frame - will a 1992 or later sub frame bolt in? Trying to kill two birds with one stone, replace the sub frame that is damaged and move to ...

...sub frame the sub frame or what ever it's called, where the motor mount sits is rusted and motor mount is loose. what can be done? replace the sub frame this job is very difficult if you dont have ...

...sub zero should make ice soon after being installed. If there is ice around the door frame of the freezer there may be a problem with the door frame heaters. There should not be ice around the door ...

...under the front of the sub-frame. Then remove the two front sub-frame bolts. Then let the front of the sub-frame down until you get just enough room to pull the alternator over the top of the

...sub-frame).  Place a jack under the rear of the sub-frame and remove the rear sub-frame mounting bolts.  Loosen the front bolts a few turns, but do not remove. Then slowly lower ...

sub frame IS SUB-FRAME REPLACEABLE-FRT END DRIVER SIDE RUSTED WHERE LOWER CONTROL ARM ATTACHES Yes it is replaceable, the whole front sub frame will have to be replaced. Auto salvage yards carry these

...sub frame I`m guessing you mean the frame under the engine & transmission. if so you have to support the engine/trans with an engine brace and disconnect every thing that is attached to the sub ...

sub frame on 2002 mercury sable support car place jack stands under sub frame. using an engine support to hold motor in place, disconnect anything that is attached to sub frame, ex: motor mounts. then

...sub frame on a 2002 hyundai Santa fe You're talking about the engine cradle? Install an engine/transmission support. Raise the vehicle and put it on jack stands. Locate a floor jack under the sub ...