Questions & Answers for: Chrysler stuck on test

...but wont go up. first just one window now all are stuck down Could very well be, but a voltage test would confirm before buying part & that not being the problem. Thanks for getting back

Ad

Question about 2007 Sebring Sedan

1 Answer

...test was ran on my 2007 Chrysler Sebring that said my intake runner controller bank was stuck ''open''. Can you help me find an answer to this. what engine? So the guy running the test could'nt point ...

Ad

...stuck on 1996 concorde just suddenly excellarated (800 rpms) car driving at 30 mph then suddenly excellerated I could not get it to stop even after putting in nuteral while driving This car has ...

Question about 1996 Concorde

1 Answer

...test done to check head gasket and cracks. Check that the fan is coming on at the correct time . If you have a viscous fan hub then replace it . Check that the auto transmission is not stuck in too ...

Question about 2001 300M

2 Answers

...stuck thermostat. Make sure the radiator and the overflow bottle are filled to the proper levels. Bleed air from the coolant system:This is best done by running the engine with the radiator cap off ...

...stuck in Park again. How do i check to see if the neutral safety switch is bad??? Hi Barb, I'm glad to help! Here's something to do first, swap the starter relay with another relay that the same. If ...

...do I have to drive a PT cruiser to reset the check engine light I replaced the thermostat when it stuck open and had a code that the engine did not heat up enough. I reconnected the battery and ...

...test says No Exhaust Gasses in the Cooling System. Turning the Heater on Full Blast helf to cool it down. ANY Ideas? Blocked radiator, have it serviced. If your engine is overheating, Try this ...

...stuck in the up position nothing yet Most common issue is bad switch, but possible bad circuit breaker. Test for power at motor. If none, test for power going to switch. If none, either bad ...

...test is to remove the PCV valve from the engine and listen to it as you shake it. A working valve usually has a Rattle sound. No rattle suggests a stuck valve. Some valves can be cleaned but this is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...