Questions & Answers for: GMC Jimmy stuck solenoid

...stuck in four high will not shift into 2 wheel trys to shift into 4 lo but wont go sounds like you have an issue with the motor on the transfer case. these do go bad quite often I believe that this ...

Ad

solenoid is stuck closed or plugged so the vapors cant escape when replaced by gas causing the fuel to back up and shut the pump off. i think the solenoid or valve as sometimes called is behind the l.

Ad

Question about 2001 Jimmy

2 Answers

solenoid is stuck or plugged. I don't remember if that one is mounted on the charcoal canister or if it mounted up buy the cross bar of the frame by the wheel well. If its remote mounted there will be

...solenoid a stuck on reverse not work code p0752 shiift solenoid stuck on No reverse is a dead giveaway of a failed transmission. You must remove it and replace it or rebuild it. P0752 code will not ...

Question about 2000 Jimmy

2 Answers

stuck in one gear and I read the code and I have a code of P7085 (i believe) Shift solenoid B electrical and I changed both Shift Solenoid A and B and the issues remained the same. Is the issue due to

Question about 2001 Jimmy

2 Answers

Solenoid's pinion gear is stuck. Have someone hit (not too hard) the starter while you try to start the car. This usually works by dislodging a stuck pinion gear. ·Make a simple test of the alternator

Question about 1997 Jimmy

1 Answer

...solenoid is stuck. To repair this, you need to open the entire liftgate, and remove the inside trim panel to get at the solenoid. You can then try manually moving the actuator arm while lubricating ...

...solenoid? If you don't hear anything, the relay or the fuse for the power to the relay could be blown. Check the fuse, first, then the relay. If those are fine, the neutral safety switch could be ...

...stuck key from ignition and cant start vehicle There is a solenoid that unlocks that when the car is put into park. Test all your fuses first but you may have a problem with that solenoid or related ...

stuck but i freed it up. I had four hi working for about a day now it blinks and goe s right back to 2hi. Changed solenoid on transfer case and fixed vacuum lines. Any idead Still sounds like a vacuum

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

1998 GMC Jimmy
1998 GMC Jimmy

1,127 Questions

1999 GMC Jimmy
1999 GMC Jimmy

1,104 Questions

2001 GMC Jimmy
2001 GMC Jimmy

838 Questions

Manuals & User Guides

Loading...