...stuck in 4hi the transfer case,transfer case motor,and axle solenoid was changed COULD BE CONTROL MODULE OR WIRING PROBLEM,BAD GROUND.RUN CODES IT SHOULD TELL YOU SINCE EVERY TIME YOU START IT RUNS ...
...also look for a broken or loose hose or pipe that might have came off.Specially if you ran over something.If none found it could just be the vent solenoid stuck in the venting position.Good
...solenoid stuck in the closed position. The solenoid is on the side of the starter on this vehicle. While you could replace just the solenoid, it more than likely hurt the starter windings. I would ...
...stuck on the flywheel or that the solenoid on the starter has gone bad....Be sure to check your ignition fuse(s), and any relays. There may be a fuse box located under the hood with fuses and relays ...
...stuck or open shift solenoid in the tranny (4L60E hydra-matic). Depending on the year and type of tranny this was a default setting to either only second or only third gear, should some electrical or ...
...stuck or open shift solenoid in the tranny (4L60E hydra-matic). Depending on the year and type of tranny this was a default setting to either only second or only third gear, should some electrical or ...
Solenoid's pinion gear is stuck. Have someone hit (not too hard) the starter while you try to start the car. This usually works by dislodging a stuck pinion gear. ·Make a simple test of the alternator
stuck open or PCV system has a vacuum leakIgnition system fault (a coil) that affects more than one cylinderTSB 03-06-04-030 contains a repair procedure for this codeTSB 03-06-04-041 contains a repair
stuck when in forward not reverse but i checked and brakes are fine used scan tool and shift solenoid a&b circuit and gear shift module communication circut codes came up is that what would cause this
Usually answered in minutes!
4,236 Questions
159 Questions
130 Questions
67 Questions
56 Questions