Questions & Answers for: Chevrolet 1500 stuck solenoid

...stuck in 1st gear you can move the shifter to 2nd but thr tranny stays in 1st It sounds like you may have a bad shift solenoid. This will cause no upshift. If you have no 2,4 or reverse you have more ...

...EGR is maybe stuck open. disconnect the vac hose at the EGR valve and see if the idle smoothes out. If the EGR is sitcking open, thats a vac leak. If that fixes it, replace the EGR solenoid

...shift solenoid in tranmission,checked for vacume leaks.engin idels good,but stalls when put in gear The torque converter clutch could be stuck, which would require transmission removal to

...stuck in acc position will not turn to be removed can turn key to start, truck runs ok remove ignition fuse to turn off is the key lock Solenoid on the coloum the issue The ignition lock cylinder is ...

solenoid.Swapping these units can blow computers.It is probaly stuck in third gear because the fuse is blown or because of open vss circuit.You will not be able to make this transmission work. Nice !!

...speedo was fixed, yes the speedo matters OD is 4th gear, the TCM can be scanned, why not do that? stuck in 2nd gear is common for TRANNY LIMPHOME it does that when sensors or solenoids go ...

...to the solenoid. if you engage the ignition switch and the engine does not turn but instead emits a repetitive clicking sound, your solenoid is stuck open or closed and will need to be

...suburban Hi Phillip:DTC P0751 - 1-2 Shift Valve Performance code. You could possibly have a valve stuck in the valve body or an internal problem.Try this...1. Clear the code and then monitor

...on chevy suburban DTC P0751 - 1-2 Shift Valve Performance code.You could possibly have a valve stuck in the valve body or an internal problem.Try this...1. Clear the code and then monitor

Solenoid's pinion gear is stuck. Have someone hit (not too hard) the starter while you try to start the car. This usually works by dislodging a stuck pinion gear. ·Make a simple test of the alternator