Questions & Answers for: Oldsmobile Regency stuck seat belts

Ad

...seat) is stuck Help! College daughter's 1994 olds 98 rear seat belt (behind driver seat) is stuck in a re-tracked postion. How do we get it out? I assume it may be twisted in there, but we can't get ...

Ad

Question about 1996 Ninety Eight Regency

1 Answer

The main belt on my 1996 oldsmoble fell off I need a diagram to fix it can you help belts just dont fall off. you need to find out why. ck tensioner pulley, tensioner and water pump. there is unsually

Ad

Question about 1998 Regency

1 Answer

Putting a belt back on... issue I have a 1988 oldsmobile regency... and I went to test the alt to do so I had to take it out and removing the belt was easy... but now I'm having some difficultly ...

Question about 1996 Ninety Eight Regency

1 Answer

power driver's seat Power driver's seat only travels forward and backward on one side of seat. Other side works fine. Seat does travel up and down properly. Power seat movement is controlled by ...

how do you change a 1998 regency serpentine belt look under your hood for the information tag on your serp belts routing. It will show you where the idler/tensioner is at. Use the appropriate size ...

Question about 1994 Ninety Eight Regency

1 Answer

does 94 olds have a timing chain or a timing belt Timing belt.Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan

can I bypass the ac compressor with a smaller serpentine belt? I know I can get a bypass pulley, but I think a smaller belt would be even easier. 1994 Olds 98 v6 I have a 1990 Olds 3.8 V6. Installed a

Question about 1998 Regency

1 Answer

serpentine belt need to now how to reroute or replace it find a diagram or take a picture of the existing belt, loosen off the tensioner, take the old belt off, put the new one on correctly following ...

serpentine belt broke and cannt figure out how it goes back on is there some part i have to remove to get it back on correctly? there should be a belt tensioner you can loosen off. loosen it, feed ...

...the water pump and back into the engine. Brad is correct. If overheating, it could be a thermostat stuck closed. A bad water pump (impeller worn down or corroded). Water pump not being turned by the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...