Questions & Answers for: strut spring moves

...strut/coil spring in the front of my car We took the strut off following the directions in the manual, and don't have a rack to lift the car into the air. I've bought a new coil spring compressor, ...

Ad

...spring compressor. Need to jack up the car and remove wheels. Re-move two lower bolts Re-move three upper strut mounts Re-move rear Rear strut assembly Now the hard part Compress the springs Remove ...

Ad

spring was turning when i turn the wheel you did not locate the springs in the latched postion and struts will turn some thats why there is a strut bearing at the top it is possible to get the springs

...spring of strut sits on strut base at bottom & see if you can feel piece of thin rubber between spring & base of strut, or if spring is up against the edge of the base (seat). Sometimes I've ...

strut/coil spring assembly back into the knuckle? Both my shop manuals say the following: ''Position the strut/coil spring assembly into the strut tower and fit the lower portion of the strut into the

Question about 1996 Contour

1 Answer

AFTER INSTALLING A STRUT, WHAT COULD IT MEAN WHEN YOU HERE YOUR SPRING CLICKING EVERY TIME YOU TURN WHEEL? spring might not be sitting in the groove on the strut and maybe moving each time you turn

Question about 2000 Sportage

2 Answers

...strut spring compressor and also a hydraulic floor jack. Without a proper spring compressor there is a serious danger of injury so don't attempt this job without it. You can rent these at many tool ...

Question about 1998 Windstar

1 Answer

...Strut and Spring AssemblyRemoval Raise the vehicle on a hoist. Remove the front wheel and tire assembly. CAUTION: To avoid damage to the 6mm drive hole in the front stabilizer bar link ball stud, do ...

...STRUT COMPRESSORS NOT COIL SPRING COMPRESSORS TO CINCH DOWN YOUR STRUT COILS TO THE POINT OF WHERE THE STRUT BEARING MOVES FREELY ( THE PART WITH THE STUDS ) THEY DONT NEED TO BE FULLY COLLAPSED JUST ...

On the front strut inside the spring there is a black plastic like cap is this suppose to move or be stationary. Should move because strut is moving.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...