Questions & Answers for: Mercury Sable strut assembly

Struts need to be replaced, I have purchased used ones. Do struts need to be compressed? Are the ones you bought complete with springs assembled? If so you can replace them as a unit. If springs are ...

Ad

strut assembly.if the strut coil spring broke you wont need a coil springcompressor.BESURE INSTALL NEW MOUNTING BOLTS AND PINCH BOLT.install the strut assembly.use a new pinch bolt .torque it to 50-67

Ad

strut assembly unit at the bottom is attached to the knuckle by two strong bolts and at the top to the vehicule frame by 3 nuts on studs. The coil spring you're talking about is mounted and compressed

...strut & coil assembly in mercury sable. Cannot gut the strut up high enough to get the bottom bolt in the a frame! You will need a compressor to shorten the strut in size to install it. Auto Zone ...

...mounting nuts of the upper strut mount. Then you can remove the nut and bolt that pinches the the rear spindle assembly to the lower strut. separate the two and pull the strut assembly out of the

Question about 2000 Sable

2 Answers

...strut is part of an assembly consisting of the strut, spring and mount. They must be removed together as an assembly. These parts can be changed individually (with the use of a tool to compress the ...

Question about 2000 Sable

2 Answers

...you are going to be working on. Remove the tire, Brake caliper, and Disc Assembly. You may have to remove the Strut assembly, in most cases you do so make sure everything is straight when you

...strut and spring assembly. what should I do? hi. the correct answer here is to replace both the springs. if one is compressed to the point where it affects camber, then the other must also be ...

2002 SABLE FRONT END KNOCKING NOISE ALL TIE RODS, BALL JOINTS AND STRUT ASSEMBLIES ARE NEW. WHEN I COATS DOWN HILL I HEAR A CLUNKING NOISE IN THE FRONT, ALSO WHILE RUNNING ON A LIGHTLY ROUGH ROAD. I ...

...strut assembly, if it is the bottom ball joint will need to be released, I have found some very tight and have had to use both a portable hydraulic tool or the heavy duty pneumatic pickle fork with ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...