strut and rotor i may have miss spell what i am looking for.it bounce a lot, and i need to fit it and i need rotor on the front wheel. i need a guide. to fit it. can you help. Good morning ...
...many thanks Dumb question, but, did you happen to the diagram on the underside of the hood, the strut tower towards sides of the motor or on the radiator
...manufacture For both the 4 cylinder and 6 cylinder engines: Under hood, driver side, engine side of strut tower, below air filter housing, mounted in fuel ...
...Jack up the car and support it on jack-stands. Remove the brake calipers and tie it up to the strut-spring. (Check your engine mount, transmission mount) Remove the cotter-pin from the tie-rod ...
strut assembly. Read on if you want the details: Shock absorbers are simple suspension dampers that control the unwanted spring motion of the vehicle's frame caused by the suspension's springs. Struts
...Mazda 626 2.5L MFI DOHC 6cyl the Fuel Filter is located under hood, driver side, engine side of strut tower, below air filter housing, mounted in fuel line. Hope helps (remember rated
...STRUT ASSEMBLY.TO INSTALL ***** INSTALL STRUT INTO THE STRUT TOWER ALIGNING THE PAINT MARKS MADE DURING REMOVAL.INSTALL UPPER MOUNTING NUTS AND TIGHTEN TO 34 - 46 FT LBS. INSTALL STRUT TO KNUCKLE ...
...shield and using a jack and a bar and chain to hold up the motor from the top lay bar across from strut to strut and secure to engine, use a jack under the engine and add pressure to remove the ...
How do I get to the top rear strut mounting bolts?? Pull back the carpeting on the sides of the trunk. look for a plastic or rubber cover and your nuts should be under there
WHAT HAPPENS WHEN STRUTS GO ON MAZDA 626 2002 it bounces up and down like a yo-yo and handles like a dump truck Generally speaking, struts are shocks which dampen the bounce when you hit a bump in the
Usually answered in minutes!
544 Questions
410 Questions
356 Questions
269 Questions
277 Questions