(09568-34000). Remove the lower arm ball joint mounting bolts Remove the strut lower arm mounting bolts Remove the hub and the knuckle assembly INSTALLATION: Reverse the order of the removal procedure
assembly-- support it properly. Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to
...2 remove the nut off the axle in the center of the hub 3 remove the two nut and bolts that hold the strut to the spindle and pull spindle out towards you. these bolts may be pressed in and you might ...
...Strut Assembly - Rear, Driver Side, KYB GR-2/EXCEL-G, Twin tube, Strut Assembly. $72 2000 - 2006 Hyundai Elantra Shock Absorber and Strut Assembly - Rear, Passenger Side, KYB GR-2/EXCEL-G, Twin tube, ...
...struts on front of 2003 hyundai elantra Are you replacing the complete strut assembly with the coil spring and strut mount already attached? Because if not, you'll need a coil spring
strut. Put the assembly on a work bench. 1. On the back side remove the snap ring. Now this is where you need a press. 2. Press the hub out of the bearing. 3. Press the bearing out of the knuckle. Now
rear suspension still pops after replacing rear shock assembly Changed out both sides of rear strut assembly and the car still knocks in the rear when driving check your stabilizer bar or the bushing
Usually answered in minutes!
1,180 Questions
1,029 Questions
656 Questions
508 Questions
493 Questions