Questions & Answers for: Chrysler Concorde strut assembly

...tie rod bushings (?), and now I have a loud squeek (sounds like bed springs) near the right front strut area. It wasn't making that sound before the work. The repair shop says it's caused by the ...

suspension Had struts put in [front and rear] few month ago. Shruts were shot. Now when I'm driving over any bumps there is alot of rattling and vibration in the front. Very noisy. On the highway its ...

rear strut install How do you remove and install rear struts on a 2000 chrylser concorde. I have a 1999 Chrysler LHS and have had the rear struts done for me. You have to remove the back seats to get ...

noise in front suspension when traveling over bumpy road. have already replaced struts. car has 177,000 miles on it and just replaced the struts. no other suspension parts have been replaced. seem to ...

My 97 Chrysler Concorde runs good but shocks/ struts need replaced to make smoother ride - i was hoping someone would have cost estimate or tell me how to repair. I am new to this town and don't know ...

strut assembly without tangling with the brake lines, or you may have to remove the brake calipers. Remove the blocks under the wheel assembly while and slowly lower it to free the strut being careful

vickiMy trunk does not stay open, does it need a fuse? Nice Car...the trunk is supported by 2 rod/struts one on each side, attached to the rear car body, and the trunk...these struts wear out and the ...

is it difficilt to replace trunk struts NO,VERY SIMPLE. TIM He might need more info. Seems for most modern cars, you pop off a retaining clip at both ends, pop off the old strut. Then pop the new one ...

Two mechanics, two different answers. We had the struts replaced on our 1997 Chrysler Concorde a couple months ago. A few weeks ago we had the front tie rods replaced and then needed an alingment. The

how to install hood struts The gas assist struts should be replaced in pairs - one at a time. Prop up the hood in such a way as to take all the weight off the struts. You can cut a piece of wood to ...