Questions & Answers for: Buick strut assembly

Need to change struts front and rear on 2003 Buick Century what special tools are needed? What assemblies besides the struts themselves are needed? It does not appear I need the bellows on front ...

...3. Remover rotor 4. Remove 35mm Castle Nut 5. Remover 3 bolts behind strut assembly 6. UNclip any ABS sensor wires 7. Pull hub out of strut assembly but be careful not to pull CV joints out of ...

...strut assembly. I need a diagrahm of parts and any helpful hints. Parts houses sell a complete assembly now,(spring and strut W/bearing) Much easier to replace the assembly,that way you don't have to ...

strut assembly unless something has failed. This is a tuff job ,you will need a strut tool for the top strut mount,then go between springs and turn strut mount cap to housing off,like unscrewing a nut

I would like to know how to change my Front struts on my 1999 buick Lesabre ??? Step by step. Hello 14006jake, Working on struts can be dangerous because the spring is under great pressure so caution ...

...strut assembly. If you jack up the side of the vehicle that is low (jack under the subframe or by the pinch weld) you sould be able to see if the spring is broken or not. If it is there is a solution ...

...the trunk compartment, carefully remove them. Remove the entire strut assembly from the car. Compress the spring and remove the strut mount from the strut. Installation is reverse of the ...

...strut assembly. It your replacing with "quick struts" reinstall and have the alignment done. If your just replacing the strut you will need to bring the old strut assemblies to a shop to have the ...

...assembly. Scribe the strut-to-knuckle for proper installation. If equipped, remove the auxiliary spring, as outlined in this section. Remove the jack pad. Install rear leaf spring compressor tool ...

replacing front struts on a 2008 buick enclave Best way is to buy complete strut assemblies. They come fully assembled with new strut mount, spring, boot and strut.